smash312 0 Posted April 3, 2007 Report Share Posted April 3, 2007 Hi guysI'm about to put a set of KW shocks and springs on - are there any other bits I should do while replacing the shocks - ie top mounts etc?Thanks! Link to post Share on other sites
purple highline monster 0 Posted April 3, 2007 Report Share Posted April 3, 2007 yeah do the top mounts and get new rear and front suspension bolts, makes life a lot easier!! the rear ones can be a killer as they are in the rear beam itself! be carefull to fully tighten the lower rear bolt fully before the cars back on the ground too, or once its lowered you cant get at the little blighter very easily! and it has to be up in the air to get it to clear the tank to remove it in the future!! Link to post Share on other sites
nivag27 5 Posted April 4, 2007 Report Share Posted April 4, 2007 I did mine at the weekend and it is supereb, anyway you might aswell replace all four bump stops while your there and wd40 all your bolts well before hand. Good luck. Link to post Share on other sites
Recommended Posts