jellsta 0 Posted July 7, 2007 Report Share Posted July 7, 2007 Hi all just bought some drilled and grooved discs off ebay and have tried to fit them to my VR, bought some new wheel bearing kits as was told to replace em while the discs were off. problem is can not get the wheel bearing into the disc??? will standard wheel bearings not fit into uprated discs? or are the discs i bought not for a VR? many thanks.... Link to post Share on other sites
ventovr6essex1 0 Posted July 7, 2007 Report Share Posted July 7, 2007 i take it you are talking about rear discs . you have to tap the the outer part of the bearing into the discs with a drift or a socket as they are a tight fit cant remember if they are different sizes if so the larger on normaly goes to the inside Link to post Share on other sites
jellsta 0 Posted July 7, 2007 Author Report Share Posted July 7, 2007 just tried that and ended up spliting the solid ring that goes in first?????? Link to post Share on other sites
ventovr6essex1 0 Posted July 8, 2007 Report Share Posted July 8, 2007 well there is somthing strange going on there as they only list 1 rear wheel bearing kit for discs or drums on gsf . so could be that the discs have been made wrong . you reall need to measure the inside of the disc with a vernia ( dont think thats how its spelt ) and the out side of the bearing as they are an interferance fit so will be very tight http://www.timken.com/industries/automotive/autoaftermarket/techtips/AutoTechTips_Vol1_Issue3.pdf i have one of these i use being a car tec https://toolstoday.co.uk/shop.php?sec=prod∏=1132 Link to post Share on other sites
Recommended Posts