madmonkee 0 Posted September 9, 2004 Report Share Posted September 9, 2004 im worried that if I take off my needles, and put um back to where I want them they are gonna be well out? How do they calibrate themselves anyhow? If I drop my needles down over the pin, is the final resting place of the needle absolute zero MPH? If it is i will drop it down that far and pull it off, put the needle at 10mph and push it back on, on my new dials this should then read zero shouldnt it?? My cars speedo starts at 10mph, not 0, new dials start at 0 (same place as the 10mph is on my old dials). Help pls Link to post Share on other sites
madmonkee 0 Posted September 10, 2004 Author Report Share Posted September 10, 2004 help???? Link to post Share on other sites
madmonkee 0 Posted September 10, 2004 Author Report Share Posted September 10, 2004 !£!£!!%$%56arding needles wont come off anyhow! Do u recon, if i pince the stem underneath the needles, with a a pair of bottle nosed pliars i could force the needle to where i want it to go??? Looks gay at the mo with 3 dials lookin mint and the other one plain jane! Link to post Share on other sites
andy 0 Posted September 10, 2004 Report Share Posted September 10, 2004 rather you than me mate....sorry but thats all I can say ;-) dials can be such a nightmare Link to post Share on other sites
madmonkee 0 Posted September 10, 2004 Author Report Share Posted September 10, 2004 got hold of a later set of vr clocks that start at 0mph. So no adjustment needed. Just un plug the new ones and plug into the old ones Im sure the clocks calibrate themselves, so putting newer ones instead of the moving the old ones should do the trick Link to post Share on other sites
Recommended Posts