Marky 0 Posted July 19, 2008 Report Share Posted July 19, 2008 Anyone know how to remove the two screws that hold the sensor into the AMM housing and what to replace them with?I've got a new sensor, the instructions suggest the screws should be star drive but alas they are not. Link to post Share on other sites
Charged VR 0 Posted July 19, 2008 Report Share Posted July 19, 2008 The srews are security Torx bits, Can normaly buy the little magnetic screwdriver bits from halfords Link to post Share on other sites
Marky 0 Posted July 21, 2008 Author Report Share Posted July 21, 2008 Hi, doesn't look like any of these: Torx heads or this guys (pic at end of postings )It is flat faced, has a central hole and the rest of the face looks like looking down on a staircase. Link to post Share on other sites
Matt W 4 Posted July 21, 2008 Report Share Posted July 21, 2008 Huh, post a picture.Mine is a torx but has the tamper resitant post in the center.But if you are careful you can get a torx bit in far enough to get the screw out. Link to post Share on other sites
Charged VR 0 Posted July 21, 2008 Report Share Posted July 21, 2008 Where are you located mate, May have the tool if you want to meet? Link to post Share on other sites
Marky 0 Posted July 22, 2008 Author Report Share Posted July 22, 2008 yeah, here is a freehand sketch. On a '94 Golf. Link to post Share on other sites
Marky 0 Posted August 26, 2008 Author Report Share Posted August 26, 2008 just to update, Was dead easy, I unscrewed the air sensor screws with molegrips. They undid very easily and were not damaged so was able to use them with the new sensor. Link to post Share on other sites
Recommended Posts