Oldirtybastard 0 Posted October 14, 2008 Report Share Posted October 14, 2008 VR6 Supercharger headgasket, where can i get one from?Doing the headgasket and need the correct type rather than vag one.ThanksTaz Link to post Share on other sites
rodney 17 Posted October 14, 2008 Report Share Posted October 14, 2008 you dont always need a special one. what stage and brand of charger are you running? Otherwse usual suspects... VF/ROTEX etc....Regal/NSracing Are you after jus altering the compression rathings?? Link to post Share on other sites
Oldirtybastard 0 Posted October 14, 2008 Author Report Share Posted October 14, 2008 Hello,its a ZE engineering stage 1 kit. Just trying to establish whether this kit requires just a standard single VAG headgasket or spacer plate with 2 gaskets (one on each side).T Link to post Share on other sites
xyber 1 Posted October 14, 2008 Report Share Posted October 14, 2008 just a normal one is fine on that amount of boost, unless your planning more, then you may aswell lower the comp now Link to post Share on other sites
CorradoVR6-n.o.s 0 Posted October 14, 2008 Report Share Posted October 14, 2008 Hello' date='its a ZE engineering stage 1 kit. Just trying to establish whether this kit requires just a standard single VAG headgasket or spacer plate with 2 gaskets (one on each side).T[/quote']you use the later US spec headgasket,spacer plate combo by splitting the gasket apart and fitting the thicker plate between. no need for two gaskets. Link to post Share on other sites
Oldirtybastard 0 Posted October 14, 2008 Author Report Share Posted October 14, 2008 Hello,thanks, you got the part number for the us spec gasket at all?The car is only running 256bhp, dont think im upping power.T Link to post Share on other sites
Oldirtybastard 0 Posted October 16, 2008 Author Report Share Posted October 16, 2008 Hello guysJust like to say thanks for your help. I have just spoken to Stealth and been advised as my car is only running a stage 1 setup ze setup under 300bhp i will not need to use the lower compression spacer plate.Hope this helps anyone else who maybe doing a charger under that kind of power.T Link to post Share on other sites
Recommended Posts