nolongervr6 4 Posted August 29, 2009 Report Share Posted August 29, 2009 Hi, I have plugged my car into vagcom have the following error00274Left Rear ABS inlet Valve - N134 Can one advise on weather this fault is with the abs module or the actual sensor? Link to post Share on other sites
craggsy 91 Posted August 29, 2009 Report Share Posted August 29, 2009 Its not the sensor I can tell you that much Link to post Share on other sites
nolongervr6 4 Posted August 29, 2009 Author Report Share Posted August 29, 2009 Cheers craggsy, I will rule that out then. Link to post Share on other sites
nolongervr6 4 Posted September 12, 2009 Author Report Share Posted September 12, 2009 I going to try replacing the Abs control unit, hopefully that will cure it.... fingers crossed...then she be back on the road! Link to post Share on other sites
nolongervr6 4 Posted September 23, 2009 Author Report Share Posted September 23, 2009 I dont have a manual and was hoping someone can confirm that the ABS contol unit is located under the ABS pump on the below picture?any help would be greatly appreciated. Link to post Share on other sites
CALICO 130 Posted September 23, 2009 Report Share Posted September 23, 2009 I am sure you are right try to make sure you get the same part number when replacing it Link to post Share on other sites
Rikki 2 Posted September 23, 2009 Report Share Posted September 23, 2009 Looks like an early pump with the seperate ecu under the rear bench?? Link to post Share on other sites
nolongervr6 4 Posted March 22, 2010 Author Report Share Posted March 22, 2010 Update- I have now replaced the Abs Pump , Controller and Rear sensor, yet i still receiving the above fault code, even after clearing the faults with vag com each time.any suggestions? James Link to post Share on other sites
Recommended Posts