diggergti 0 Posted May 31, 2010 Report Share Posted May 31, 2010 Hay! Im looking for some ways to squeeze some more power from my 96 vr6 golf. I have allready fitted an induction kit, 6 branch maniflod, decat pipe and exhaust system. but im not looking to go down the supercharger rout yet. Any ideas Anybody? Link to post Share on other sites
AJmk2 2 Posted May 31, 2010 Report Share Posted May 31, 2010 Start removing all of the un needed interior if you can should make it quite a bit quicker. Link to post Share on other sites
xyber 1 Posted May 31, 2010 Report Share Posted May 31, 2010 Final drive from a G60, decat/sport cat, 263 cams, schrick inlet. All then still worth having should you charge later.Most induction kits are shite, apart from a fully enclosed type like a CDA or a Viper. Link to post Share on other sites
diggergti 0 Posted June 6, 2010 Author Report Share Posted June 6, 2010 Thanks Guys. the trim is allready done away with in mine ive even got a spot weld drill and removed all the unnessary steel like the rear seat frame saet belet hangers etc. I got a Carnbonio induction kit on there i didnt think it would do much but i got it for free so wacked it on! Its just a carbon fiber tube that go's from the airflow meater down inside the inner wing. Link to post Share on other sites
The Monk 50 Posted June 10, 2010 Report Share Posted June 10, 2010 Keep the spare wheel though Link to post Share on other sites
VR6Wherry 0 Posted June 11, 2010 Report Share Posted June 11, 2010 +1 on the spare wheel!!what Xyber said go for cams next. Link to post Share on other sites
diggergti 0 Posted June 13, 2010 Author Report Share Posted June 13, 2010 Im goin to have a good look for some cams im planing to get hold of another engine and buld it up over time meanwhile i will continue to kick the current engine's head in i replaced the cam chains and tenshoners last week Link to post Share on other sites
diggergti 0 Posted June 13, 2010 Author Report Share Posted June 13, 2010 Im goin to have a good look for a set of cams im planing on geting hold of another engin and bulding it up with lots of goodies. I replaced the cam chain and tenshioners last week so i can continue to kick the current motor's head in. Link to post Share on other sites
diggergti 0 Posted June 13, 2010 Author Report Share Posted June 13, 2010 Good point i aint got a spair wheel! ANOTHER THING any ideas on where to get hold of a baffled sump from? Link to post Share on other sites
Recommended Posts