joer_vr6 0 Posted July 29, 2010 Report Share Posted July 29, 2010 Not sure if this is posted in the the right section.I have striped the rear interior out of my vr and in a few months when i have finaly tackeled the rust issue i will be wanting to fit a half show cage with rear strut brace and four point harness seatbelts.What do the seabelts attach to at the back the brace or the cage and if so has anybody got any picture of what they have done so i can see how it all goes together.The cage i want to install is a half show cage with the big cross where the rears shoulds be. Link to post Share on other sites
craggsy 91 Posted July 29, 2010 Report Share Posted July 29, 2010 If its only a bolt in jobbie then I wouldnt put belts on the cage personally......would prefer them attached to the original belt holes Link to post Share on other sites
squid1 0 Posted July 29, 2010 Report Share Posted July 29, 2010 rear belt holes thts where mine is! n if u put thm on a bolt in cage or brace it wont pass a mot has to b welded in mate Link to post Share on other sites
Recommended Posts