Lil help needed!

[Sikky 0]

Alright guys, ive not been on for a while, but while ive got chance i just wanted to ask for some help incase i end up wasting my hard earned pennies.

Im wantin to order a de-cat pipe for my golf vr6 and it currently has a full magnex system on it, it was on there when i bought the car, im wondering if a milltek decat will bolt to it? ive been lookin on venom motorsport and i dont want to spend to much on one is all, only thing is there are no sizes shown? does this matter or not? maybe a dumb question as im not the most clued up on this sorta stuff just yet.

Thanks for any help i appreciate it!

[Gazbarber1982 3]

From what I know, all the off the shelf systems are near enough the same size as standard. I fitted my milltek directly to my standard cat and fitted a milltek decat 3 months later. There all about 55mm I think. Buy a new sleeve connector from trade parts specialists (TPS), it's the cheapest place for them and there the right size! (Connects the cat / decat to the centre piece of exhaust) Become a premium member and you'll save even more on it.

[Gazbarber1982 3]

From what I know, all the off the shelf systems are near enough the same size as standard. I fitted my milltek directly to my standard cat and fitted a milltek decat 3 months later. There all about 55mm I think. Buy a new sleeve connector from trade parts specialists (TPS), it's the cheapest place for them and there the right size! (Connects the cat / decat to the centre piece of exhaust) Become a premium member and you'll save even more on it.

[Sikky 0]

Thanks for the reply, i actually rang the shop to confirm aswel just to make sure and aparantly its all good, cheers tho ill look into gettin a sleeve once the decat arrives.