temprature gauge / fan

[geo7087 11]

ok so heres the current issue doing my head in on the VR

the temp gauge in the car does not read, at all, does not go up stays at the very bottom

the fan will cut in once the ignition is off, even if the car has only been turned on then immediately off when cold, it will then stay on for a good 5 to 10 minutes at leats before dyeing out, it does this everytime the ignition has been switched off after ignition has been on.

I havent noticed the fans kicking in whilst the cars bee driving either but dont seem to have any obvious overheating issues that im aware of?

...help! lol

[b19drg 0]

Cant believe your selling , saw your add on piston heads , you done so much since you had it , be a shame to let it go !

[Ben Seabrook 4]

either the fan control unit under the expansion tank or the temp sensor mate I would think

[geo7087 11]

Thanks Ben ill look into both

B19 DRG, still not certain, ive had an odder of 3k cash, so its that or sell the TT comps for 300 quid which ive been offered too and go for a wheel change in the new year

[geo7087 11]

Bumping this again,

I have changed the Blue temp sensor at the same time as doing a coolant flush, still no temp reading inside the car

Im going to change the fan control modeule asap for the fan, but out of interest the yellow plug next to the blue sensor in the thermo housing, what does this do?