tjsmudger 2 Posted January 18, 2011 Report Share Posted January 18, 2011 How much am I looking at to purchase a professional standard polished inlet manifold? Newly polished to me. Many thank. Link to post Share on other sites
tjsmudger 2 Posted January 18, 2011 Author Report Share Posted January 18, 2011 A rough estimate??? Link to post Share on other sites
ez_101 1 Posted January 18, 2011 Report Share Posted January 18, 2011 £70-£80 ish... probs best to do it yourself though mate! Link to post Share on other sites
tjsmudger 2 Posted January 18, 2011 Author Report Share Posted January 18, 2011 Thank you, for the info. Many thanks Link to post Share on other sites
ez_101 1 Posted January 18, 2011 Report Share Posted January 18, 2011 No worries mate there are plenty of guides on here if you want to do it yourself!! Link to post Share on other sites
jasonoldy69 1 Posted January 18, 2011 Report Share Posted January 18, 2011 Just started wet and drying mine today with 80grit and it's looking ace Link to post Share on other sites
ez_101 1 Posted January 18, 2011 Report Share Posted January 18, 2011 Good work, cant beat abit of DIY!!! Link to post Share on other sites
russj249 2 Posted January 18, 2011 Report Share Posted January 18, 2011 Just started wet and drying mine today with 80grit and it's looking acewait till you get to the 2000! are you using a flat sanding block? friend of mine tried something similar by hand and was covered in ripples and uneven patches Link to post Share on other sites
ez_101 1 Posted January 18, 2011 Report Share Posted January 18, 2011 Try spraying abit of WD40 when using a low grade grit sandpaper!! * tip of the day* Link to post Share on other sites
jasonoldy69 1 Posted January 19, 2011 Report Share Posted January 19, 2011 Just started wet and drying mine today with 80grit and it's looking acewait till you get to the 2000! are you using a flat sanding block? friend of mine tried something similar by hand and was covered in ripples and uneven patchesUsing a block for the majority, except for the branched part.Been using soapy water to begin with. Still experiemting so going to give WD a try next yeah Link to post Share on other sites
hvr6 88 Posted January 19, 2011 Report Share Posted January 19, 2011 pm MJ on here he does a bit of polishing and a good job too :-)http://www.vr6oc.com/user.php?id.4915 Link to post Share on other sites
Recommended Posts