leespiro 9 Posted February 19, 2011 Report Share Posted February 19, 2011 hi guys looking to get a 6 branch mani what is the best for more torque, i just had mine remapped with 268 cams miltek decat exhaust and air filter which produced 212bhp and 265nm of torque what extra gain would i get with the 6 branch thanks Link to post Share on other sites
oldmandon 1 Posted February 19, 2011 Report Share Posted February 19, 2011 have you had anything else done? ie chip etc?As far as 6 branh goes, it seems the most popular one on here is racelands, but you could go all miltec!!!!!! Link to post Share on other sites
leespiro 9 Posted February 19, 2011 Author Report Share Posted February 19, 2011 the chip has been remapped Link to post Share on other sites
Madrocker 0 Posted February 19, 2011 Report Share Posted February 19, 2011 Tbh it's almost impossible to predict what gains you will get due to the many many variables, plus you would need to remap again to get the full potential from the additional mods. If I had to have a guess the I would say you would gain around a 2-5% gain in bhp/torque.Also there is the potential of actually reducing power if you don't get your car mapped after you fit the 6 branch, I know of many Scoobys that have LOST up to 20Bhp by installing a sports exhaust system and induction kit. Link to post Share on other sites
aaronmk2 3 Posted February 19, 2011 Report Share Posted February 19, 2011 Wouldnt bother with a 6 branch theres hardly any gains the standard manifold flows pretty well if i was you id port match your exaust manifold instead and while your at it port the inlet aswell and you will see better gains than a 6 branch Link to post Share on other sites
craggsy 91 Posted February 19, 2011 Report Share Posted February 19, 2011 I never bothered with a 6 branch on my car, and ran close to 300 bhp without one. Also dont have one on the R32 Link to post Share on other sites
Recommended Posts