grantnunn 0 Posted March 19, 2011 Author Report Share Posted March 19, 2011 WELL IVE PULLED THE BUZZER OUT AND JUST GONNA KEEP MY EYE ON THE TEMP FOR NOW TILL I CAN AFFORD WORK Link to post Share on other sites
Gazbarber1982 3 Posted March 20, 2011 Report Share Posted March 20, 2011 The buzzer is to warn you that the oil pressure is either too low or too high. You might want to check more than the oil temperature. Link to post Share on other sites
makster28 0 Posted March 20, 2011 Report Share Posted March 20, 2011 is this the buzzing noise that lasts for about 10 seconds then goes off after turning the ignition on? i thought this was normal hope so anyway mine does it? Link to post Share on other sites
Gazbarber1982 3 Posted March 20, 2011 Report Share Posted March 20, 2011 The only buzz you should get is if your lights are on and your door is open. Buzz whilst the engine is running is a bit of a problem Link to post Share on other sites
kentyboy 0 Posted March 20, 2011 Report Share Posted March 20, 2011 best get your oil pressure checked,could get very expensive otherwise....or fit an oil pressure gauge to keep an eye on things..... Link to post Share on other sites
ROBSVENTO 0 Posted March 20, 2011 Report Share Posted March 20, 2011 Yer i saw there is a low pressure warning, high pressure waring and a oil temp aswell... 3 sensors in that housing, did you replace both high and low oil pressure switch's..The oil temp one does sod all as mines dissconnected due to me snapping the top of the bloody sender off lol, the other high and low are most important... Link to post Share on other sites
makster28 0 Posted March 21, 2011 Report Share Posted March 21, 2011 ah ye one of mine is broke the spade as snaped clean off its the one with the green wire the other 2 below it are conected its like a triangle effect yes? shud i be worried cheers guys Link to post Share on other sites
makster28 0 Posted March 21, 2011 Report Share Posted March 21, 2011 probly daft question but were do i look to get oil temp reading as well? Link to post Share on other sites
Madrocker 0 Posted March 21, 2011 Report Share Posted March 21, 2011 when the car is running its on the MFA, press the button on the right column leaver until the LCD screen displays the oil temp. Just so you know it wont read anything until your oil gets to 80 degrees i think it is Link to post Share on other sites
gary.scales 0 Posted March 21, 2011 Report Share Posted March 21, 2011 its 50, close :-) Link to post Share on other sites
makster28 0 Posted March 22, 2011 Report Share Posted March 22, 2011 ok thanks so as i mentioned the green wire which is broke amongst the oil sensors will i still get a reading and when i do at what temp shud i start to worrie and would there be a solution for high oil temps ,cheers Link to post Share on other sites
Lukey. 381 Posted March 22, 2011 Report Share Posted March 22, 2011 up to about 110-114 is still the high end of fine Link to post Share on other sites
makster28 0 Posted March 22, 2011 Report Share Posted March 22, 2011 thanks mate havent yet played with the trip comp yet il keep a eye onit Link to post Share on other sites
Recommended Posts