sadken 0 Posted March 19, 2011 Report Share Posted March 19, 2011 Hello there.I am fitting new front and rear speakers and need to wire them to my Kenwood amp in the boot.I have routed the RCAs no problem to behind the HU and all the power and remote leads are in place.I have fitted the new speakers to the existing pos and neg wires.When I did this on my last VR, it was a nightmare routing new wires to the amp in the boot because of the difficulty in getting wirse past the big white Molex plugs.Could you guys offer some advice on the best way to go about this?Many thanksMike Link to post Share on other sites
Lukey. 381 Posted March 20, 2011 Report Share Posted March 20, 2011 Wire them up to the wires at the tweeters, then use the standard wiring that already rubs through the multi connector at the door Link to post Share on other sites
Recommended Posts