dan_a 1 Posted April 12, 2011 Report Share Posted April 12, 2011 Hi all,Hope all is well with everybody!I need to replace the tensioner on my VR6. I'm going to do it myself cause after reading the guide on here it looks dead easy.I have been offered an OBD1 unit but my car is OBD2. Will it fit my car okay? From what I can tell they are the same?Thanks! Link to post Share on other sites
Gazbarber1982 3 Posted April 12, 2011 Report Share Posted April 12, 2011 Yeah they are the same Link to post Share on other sites
dan_a 1 Posted April 12, 2011 Author Report Share Posted April 12, 2011 Yeah they are the sameGreat was sure they were. Thanks for confirming dude! Link to post Share on other sites
gary.scales 0 Posted April 12, 2011 Report Share Posted April 12, 2011 may be a good idea if you replace the tensioner pulley too as mine went two weeks after I changed the belt. May have just been a coincidence, but didnt seem like it..... Link to post Share on other sites
dan_a 1 Posted April 12, 2011 Author Report Share Posted April 12, 2011 Ta for the advice Gary. I will be fitting a fully refurbished unit complete with pulley. Link to post Share on other sites
Recommended Posts