dan_a 1 Posted July 2, 2011 Report Share Posted July 2, 2011 I need to replace three ABS sensors on my 1995 Golf VR6. Both the rears and drivers side front.Is this a ball ache of a job? I understand doing the rears involves getting under the rear bench seat. Is this correct?Any clues as to how much if I took to a garage?Any advice gratefully received! :-) Link to post Share on other sites
dan_a 1 Posted July 3, 2011 Author Report Share Posted July 3, 2011 Anyone? Link to post Share on other sites
Lukey. 381 Posted July 5, 2011 Report Share Posted July 5, 2011 looking at the bentley manual yours should be on the newer teves 20 ABS, the control module should be built into the ABS pump, on older cars the control module is under the rear seat.the manual does not tell you how to go about replacing the sensors though, the only advice it gives is to not twist the wires and tighten the bolt to 10Nm Link to post Share on other sites
dan_a 1 Posted July 5, 2011 Author Report Share Posted July 5, 2011 Thanks for your reply Lukey Link to post Share on other sites
Recommended Posts