Justvr6 17 Posted August 25, 2011 Report Share Posted August 25, 2011 Hi guys, i may have been lucky to have aquired a set of vary rare original dealer option corroda vdo guages ( oil pressure and battery volts)Can anyone please advise me, do i have to change the oil pressure switch for a dual pole version to wire into for these guages to work???I have noticed on the vr6 engine it has two oil pressure switches. So if i do have to change switch which one do i change??There must be lots of vr6 owners out there who have wired in oil pressure gauges.Please help.î„… Link to post Share on other sites
Lukey. 381 Posted August 25, 2011 Report Share Posted August 25, 2011 you need a VDO twin pole 10 bar sender that has a 0.5bar low pressure warning and a 10x1 thread pitch.Replace the low sender, right as you look down at them.Its not a cheap sender, ~£50 Link to post Share on other sites
Justvr6 17 Posted August 25, 2011 Author Report Share Posted August 25, 2011 Thanks lukey, much appreciated. Will end up costing me a bloody fortune time i buy the guages, and make a loom up etc. Link to post Share on other sites
Recommended Posts