v_dubberoon 0 Posted October 18, 2011 Report Share Posted October 18, 2011 Hi all, ive done a load of reading on the topic and have a pretty good grasp of what's needed, what the engine can take etc.....Im just wondering where on the inlet to fit my injectors???Ive got direct port crossfire injectors that in intend to tap directly into my inlet manifold.any advice on this side would be great, ive been told the closer to the throttle body as possible the better.cheers in advance all ollie Link to post Share on other sites
CALICO 130 Posted October 18, 2011 Report Share Posted October 18, 2011 I have seen them in the front of the manifold so as they are sucked into each port where you can see the 6 different routes on the front of the nanifold. Link to post Share on other sites
v_dubberoon 0 Posted October 18, 2011 Author Report Share Posted October 18, 2011 spot on cheers Link to post Share on other sites
bungy 2 Posted October 18, 2011 Report Share Posted October 18, 2011 Stiggie has an inlet manifold with them in. He might be able to post a picture. Link to post Share on other sites
Ben Seabrook 4 Posted October 18, 2011 Report Share Posted October 18, 2011 Stiggie has an inlet manifold with them in. He might be able to post a picture. Might be able to ! I doubt it so I will help the simpleton out ;) Link to post Share on other sites
v_dubberoon 0 Posted October 18, 2011 Author Report Share Posted October 18, 2011 you legend mint is that mate thanks Link to post Share on other sites
v_dubberoon 0 Posted October 18, 2011 Author Report Share Posted October 18, 2011 Do you happen to remember what size drill bit and tap I need? Suppose it'll be easy enough t suss out my sen, just thought I'd pick your brains while I can lol Link to post Share on other sites
Recommended Posts