GordonC 20 Posted November 9, 2011 Report Share Posted November 9, 2011 Hi guys, I'm doing my timing chains and the inner intermediate sprocket just wont seem to line up with the markings the crank sprocket is bang on but the intermediate one is still slightly out will this make a difference ?Thanks, Gordon Link to post Share on other sites
Daverse 175 Posted November 9, 2011 Report Share Posted November 9, 2011 You might be able to get away with that clearance, but personally I would take the tensioners off and reset the inner sprocket to correct timing, then you know your safe Link to post Share on other sites
GordonC 20 Posted November 9, 2011 Author Report Share Posted November 9, 2011 but when I move it one tooth its too far It just doesnt seem to line up exactly if I move the crank slightly then it can line up and the crank is then out by a millimeter so do you reckon it will be ok mate ? Link to post Share on other sites
legvw 0 Posted November 9, 2011 Report Share Posted November 9, 2011 I'd say that's fine, like you said, 1 tooth out is a massive difference. Link to post Share on other sites
GordonC 20 Posted November 9, 2011 Author Report Share Posted November 9, 2011 Managed to get it sorted, Just left it the way it is so hopefully its fine lol Link to post Share on other sites
Recommended Posts