filtee 0 Posted December 2, 2011 Report Share Posted December 2, 2011 Well, i had/have a minor problem starting my vr when the engine is warm. It turns over for 3-4 seconds before firing. Its not too bad but a bit annoying. I thought/think its the crank sensor as ive had this prob before on a previous vr. Ive put another sensor on which is used/not new and the problem is still there. Im guessing that the one ive put on is slightly goosed too. What do you guys reckon? Is there anything else it could be? It runs spot on apart from that. thanks Link to post Share on other sites
filtee 0 Posted December 2, 2011 Author Report Share Posted December 2, 2011 My new threads dont show up unless i post a reply. Link to post Share on other sites
oldmandon 1 Posted December 2, 2011 Report Share Posted December 2, 2011 They don't show to you, but everyone else can see. You won't see until someone else replies........ Link to post Share on other sites
filtee 0 Posted December 2, 2011 Author Report Share Posted December 2, 2011 Oh, i see. Link to post Share on other sites
Lukey. 381 Posted December 2, 2011 Report Share Posted December 2, 2011 Does it cold start pretty much instantly? Link to post Share on other sites
filtee 0 Posted December 3, 2011 Author Report Share Posted December 3, 2011 Yes. Link to post Share on other sites
Lukey. 381 Posted December 3, 2011 Report Share Posted December 3, 2011 That rules out residual fuel pressure then Link to post Share on other sites
Biggazvr6 0 Posted December 3, 2011 Report Share Posted December 3, 2011 Doubt it's that crank sensor ad it was fine on mine. My new one I've put on is exactly the same as the old one in regards to starting times. Link to post Share on other sites
chazvr 1 Posted December 4, 2011 Report Share Posted December 4, 2011 coilpack wearing out? Mine had similar problems and it turned out, one of the terminals had corroded on the coilpack where one of the leads go on. Link to post Share on other sites
filtee 0 Posted December 4, 2011 Author Report Share Posted December 4, 2011 I'll check that. Thanks Link to post Share on other sites
Recommended Posts