Vw_owner 1 Posted December 2, 2011 Report Share Posted December 2, 2011 hello, i plan on installing a voltage and oil pressure vdo gauges on my vr corrado, going to get a plate that will replace the cassette holder to house them, does anyone know exatly which oil pressure switch i will need? heres the plate , turns out its for lhd but im sure they do it for rhdhttp://www.ebay.co.uk/itm/VW-Corrado-VDO-Gauge-Holder-VR6-G60-16V-Black-2Hole-93-/170605577843?pt=UK_CarsParts_Vehicles_CarParts_SM&hash=item27b8e28673also is this what i need for the pressure switch to go in?http://www.ebay.co.uk/itm/LUPO-POLO-GOLF-GTI-TURBO-CORRADO-VR6-G60-16V-OIL-PRESSURE-GAUGE-ADAPTOR-MLR-IE-/150706662176?pt=UK_CarsParts_Vehicles_CarParts_SM&hash=item2316d12b20 cheers Link to post Share on other sites
Lukey. 381 Posted December 3, 2011 Report Share Posted December 3, 2011 You need a 10 bar gauge and sender with an m10x1 thread and you could use a t piece like that or a neater, better way is to get a twin pole sender. Then you can connect your original low pressure warning light and the new gauge wire up to the same place and you aren't introducing another potential problem pointAnother point if you get a twin pole sender is to make sure you get a sender with a low pressure warning of 0.5 bar, 0.8 is a bit too high really Link to post Share on other sites
Vw_owner 1 Posted December 3, 2011 Author Report Share Posted December 3, 2011 cheers for that lukey, im guessing you have vdo gauges aswell? any chance of some part numbers for the sender? so many to choose from, also on normal driving what is your oil pressure, just found a sender like you mention except the low pressure warning comes on at 0.25 bar this ok? or to high? Link to post Share on other sites
Lukey. 381 Posted December 3, 2011 Report Share Posted December 3, 2011 yea that's actually the default level of the original low pressure sender you would replace. Last time I looked the lowest I could find was a 0.5 and its what I run, but not bothered as I thought about it and decided that 0.25 BAR is a bit low anyway lolOn cold start it will up to 6 driving and over and about 4 on cold idle, when hot it will hover at 2 - 4 driving, obviously the harder you drive the higher it goes, full throttle at 6krpm can hit over 5 and 2 or a bit lower on idle.I don't have a part number on my invoice for either the gauge or sender, but they are both vision range 10BAR VDO. The proper VDO sender is fairly costly, I think mine was over 50 quid, but I had read that mixing makes doesn't always work and wanted to be sure it would work fine.I got them from here http://www.etbinstruments.com/Sensors_ancillaries.htm I rang him up and told him the exact specs I wanted ie thread pitch and low pressure warning Link to post Share on other sites
Vw_owner 1 Posted December 3, 2011 Author Report Share Posted December 3, 2011 sound, cheers i'll have a butchers.. Link to post Share on other sites
Recommended Posts