VeedubVR 0 Posted January 28, 2012 Report Share Posted January 28, 2012 while the engine is out, it would be rude not to tart the engine and gearbox up a bit Im going to use brush paint compared to spray, just due to ease, but which to go for?The VR gets stupid hot as we all know , so which paint is best suited?Ive been told Hammerite will be fine if used thinly Then again others have said to use enamel paint.... I was looking through Frost's catalogue and they have quite a wide range, maybe too many, and i have no idea which to go forany ideas?Thanks Link to post Share on other sites
Daverse 175 Posted January 28, 2012 Report Share Posted January 28, 2012 I'm just using stove paint mate, temperature resistant upto 300 degree or so. the only issue is that its matt black, which doesnt bother me, but depends how nicer finish your after? Link to post Share on other sites
VR6Pete 1,455 Posted January 28, 2012 Report Share Posted January 28, 2012 Stealth racing just use Hammerite so assume its ok Link to post Share on other sites
VeedubVR 0 Posted January 28, 2012 Author Report Share Posted January 28, 2012 oh well if its good enough for stealth.... Link to post Share on other sites
VR6Nat 9 Posted January 29, 2012 Report Share Posted January 29, 2012 I was told Hammerite would be fine so ill be using that with a brush too Link to post Share on other sites
bungy 2 Posted January 29, 2012 Report Share Posted January 29, 2012 Hammerite is self levelling, just don't be tempted to over brush it. Link to post Share on other sites
lumoxs 0 Posted January 30, 2012 Report Share Posted January 30, 2012 hammerite here too.... Link to post Share on other sites
Recommended Posts