paceo 22 Posted May 22, 2012 Report Share Posted May 22, 2012 i have a golf vr6 early obd1 280mm setup but switching to a 312mm conversion.im finding it hard to find the correct brake pads with the wear sensor. i think you can use 288mm pads but they dont list them with the sensor???ive got the 312mm pads but the sensor wire is on the opposite end of the pad. i can fit them but the brake light is going to stay on all the time as the wires are cut!! Link to post Share on other sites
Lukey. 381 Posted May 23, 2012 Report Share Posted May 23, 2012 The sensor is just a closed circuit, if you can't find any pads that have the correct wires just bridge the plugs connectors and the light will go out Link to post Share on other sites
CALICO 130 Posted May 23, 2012 Report Share Posted May 23, 2012 Have you tried disconnecting the wires and seeing if the light stays on? Link to post Share on other sites
Recommended Posts