djmac 1 Posted July 1, 2013 Report Share Posted July 1, 2013 Hi, just been looking over the vr6 today and noticed 2 connectors were just about gone, so i 100% know i need these connectors as one is the throttle body sensor so know my car idles at 1900rpm, which isnt really a problem as i know a new connector will sort this, But im having some issues with coolant? i thought my fans weren't coming on, but they do, pretty much when my header tank is spilling!I had loads of issues with my 16v to do with rad and fans, hoping this is nothing to serious, i did have the inlet manifold off the other day, have i forgotten something?Cheers Dan Link to post Share on other sites
djmac 1 Posted July 1, 2013 Author Report Share Posted July 1, 2013 Also i found this wire hidden in the bay which im certain has never been plugged in?It comes out the main harness and is a blue'ish colour? Link to post Share on other sites
Lukey. 381 Posted July 1, 2013 Report Share Posted July 1, 2013 If its on the wires that lead to the throttle body it doesn't apply for uk cars so was never used. Link to post Share on other sites
djmac 1 Posted July 1, 2013 Author Report Share Posted July 1, 2013 Thaught itmay have just been blanker! im just going to have to struggle on and replace the other connectors and solvethe boiling issue? Link to post Share on other sites
djmac 1 Posted July 9, 2013 Author Report Share Posted July 9, 2013 I got another connector and re soldered it in, idle is fine! got another post about the heating issue! But still dont know where this wire has come from...? Link to post Share on other sites
djmac 1 Posted July 11, 2013 Author Report Share Posted July 11, 2013 No one know where this connector goes? Not sure if this should be somewhere? please help?Thanks Link to post Share on other sites
Lukey. 381 Posted July 11, 2013 Report Share Posted July 11, 2013 Take another picture of it but zoomed out so you can see the loom, where it is and what's around it. Link to post Share on other sites
Recommended Posts