daimondsilver 0 Posted April 21, 2005 Report Share Posted April 21, 2005 just been on the lathe and bored out a spare throttle body i sourced from e-bay. Does anyone know if it can just be bolted straight on? Link to post Share on other sites
Eat this 2 Posted April 21, 2005 Report Share Posted April 21, 2005 afaik yep Link to post Share on other sites
VRmonster 1 Posted April 21, 2005 Report Share Posted April 21, 2005 wtf does afaik mean man. oh, and it will go on no probs. Link to post Share on other sites
Eat this 2 Posted April 21, 2005 Report Share Posted April 21, 2005 afaik = as far as i know Link to post Share on other sites
daimondsilver 0 Posted April 22, 2005 Author Report Share Posted April 22, 2005 cheers for the replys. will it have any effect on the engine management/ fueling? Link to post Share on other sites
daimondsilver 0 Posted April 27, 2005 Author Report Share Posted April 27, 2005 ok. i put the bored out tb on but its idling above 1000rpm and sometimes eraticaly. I noticed that the plate had a some clearance compared to the original which looks like transision fit or slide fit. Would the small gap be the cause of the wild idling? Link to post Share on other sites
pete8tch 0 Posted April 27, 2005 Report Share Posted April 27, 2005 tryn a gasket of some kind Link to post Share on other sites
Recommended Posts