Tattoomang60 0 Posted August 5, 2013 Report Share Posted August 5, 2013 Hello all I need some info .OK a lot of info on how to fit a vr lump into a mk2 golf.Any help welcome. :S Link to post Share on other sites
michael5556 247 Posted August 6, 2013 Report Share Posted August 6, 2013 What parts have you got so far? Link to post Share on other sites
Tattoomang60 0 Posted August 6, 2013 Author Report Share Posted August 6, 2013 Iv av got a running vr but body is shot so gonna av motor out and in to a mk2 golf:-) What things am I gonna need any help very welcome:-) Link to post Share on other sites
Daverse 175 Posted August 6, 2013 Report Share Posted August 6, 2013 Engine, loom, transponder, slimline fans i believe, and im told you have to skim the back engine mount down a tad or the block sits too high. Not sure what you do when it comes to putting the loom to the ce1 fuseboard.Oh and a turbo Link to post Share on other sites
michael5556 247 Posted August 7, 2013 Report Share Posted August 7, 2013 If you have the whole mk3 then I would use the subframes, suspension, brakes, everything basically. If you use the mk3 subframe and mounts you don't have too cut the mount down. As for ce1 it depends if your mk2 is 90spec or not. Link to post Share on other sites
Tattoomang60 0 Posted August 7, 2013 Author Report Share Posted August 7, 2013 I was gonna use the hole mk3 fuse box everything justvswap it all into the mk2 is this poss also can I usecmk3 steering rack? I av loads of q&a s .Sorry PEPs lol:-) Link to post Share on other sites
michael5556 247 Posted August 7, 2013 Report Share Posted August 7, 2013 It's your in car wiring like headlight switches, etc thats the problem... Especially if your ce1. And yes you can use steering rack etc.. Link to post Share on other sites
Tattoomang60 0 Posted August 8, 2013 Author Report Share Posted August 8, 2013 Its gonna be a track car so lights aynt to Mitch of a problem as sutch. Link to post Share on other sites
Tattoomang60 0 Posted August 30, 2013 Author Report Share Posted August 30, 2013 That's mk3 vr striped now to find a mk2 shelll Link to post Share on other sites
michael5556 247 Posted August 31, 2013 Report Share Posted August 31, 2013 Start a build thread! Link to post Share on other sites
daveyboy 897 Posted August 31, 2013 Report Share Posted August 31, 2013 For the switches and Everything to work properly you could put the mk3 dash in the mk2. I'm not sure how easy it is to do but I've seen a few done and it looks better than the mk2 dash in my opinion Link to post Share on other sites
Recommended Posts