mattvr6 133 Posted November 10, 2013 Report Share Posted November 10, 2013 Are engine risers avaliable for mk3 vr6, noticed my sump has took a bit of a battering over the summer lol any help appreciated Sent from my iPhone using Tapatalk Link to post Share on other sites
palmer 17 Posted November 10, 2013 Report Share Posted November 10, 2013 Hockey pucks ;-) Sent from my GT-I9505 using Tapatalk VR6Pete and daveyboy 2 Link to post Share on other sites
daveyboy 897 Posted November 10, 2013 Report Share Posted November 10, 2013 You can get a pack of 3 or 5 off eBay for about a tenna Sent from my LT26i using Tapatalk Link to post Share on other sites
Daverse 175 Posted November 11, 2013 Report Share Posted November 11, 2013 Yep, hockey pucks and longer bolts should see you right Sent from my GT-I9300 using Tapatalk Link to post Share on other sites
mattvr6 133 Posted November 11, 2013 Author Report Share Posted November 11, 2013 Hockey pucks?!sizes??Sent from my iPhone using Tapatalk Link to post Share on other sites
bennyk 1,238 Posted November 11, 2013 Report Share Posted November 11, 2013 I'm very interested in this, the golfs due an oil n filter, but I don't intend on draining the oil all over a speed bump somewhere!!! Link to post Share on other sites
palmer 17 Posted November 11, 2013 Report Share Posted November 11, 2013 Just standard hockey pucks bud. Pretty sure theres a guide somewhere. Jus drill hole in middle and get some longer bolts, pretty straight forward Sent from my GT-I9505 using Tapatalk bennyk 1 Link to post Share on other sites
mattvr6 133 Posted November 12, 2013 Author Report Share Posted November 12, 2013 Thanks mate I'll have a look in2 it Sent from my iPhone using Tapatalk Link to post Share on other sites
mattvr6 133 Posted December 4, 2013 Author Report Share Posted December 4, 2013 Just ordered some hockey pucks to raise the engine as I've found that after fitting a lower strut brace the gearbox diff sits very close and on hard acceleration there's a bad vibration only had it since the brace fitted Sent from my iPhone using Tapatalk Link to post Share on other sites
CALICO 130 Posted December 5, 2013 Report Share Posted December 5, 2013 If its a generic mk3 lower strut brace your lucky it fits at all they are rumoured not to fit the VR6. You can also fit the R32 sump which is shallower but will shatter if hit too hard. Link to post Share on other sites
mattvr6 133 Posted December 5, 2013 Author Report Share Posted December 5, 2013 Mine fits ok just gearbox hits it :/Sent from my iPhone using Tapatalk Link to post Share on other sites
Recommended Posts