Jakeyb 23 Posted January 28, 2014 Report Share Posted January 28, 2014 im sure its been covered , but wen you remove the front bolt on the drivers side bottom arm it fouls the sump ... so is it a case of removing the rear mount to enable the engine to swing n it gives you the room or is there a knack ? i have to remove my sump anyways to re seal it as there is a leak n its been bodged but for future reference would be nice. Link to post Share on other sites
Lukey. 381 Posted January 28, 2014 Report Share Posted January 28, 2014 undoing the rear mount bolt (possibly front aswell cant remember) then jacking on the sump with some wood in between to avoid damage, it will clear the bolt. Link to post Share on other sites
Jakeyb 23 Posted January 28, 2014 Author Report Share Posted January 28, 2014 well im using a 2 post ramp atm as changing the box aswell so im hoping this time ill just remove the sump Link to post Share on other sites
Lukey. 381 Posted January 28, 2014 Report Share Posted January 28, 2014 could use a transmission jack? Link to post Share on other sites
Vr6pates 2 Posted January 28, 2014 Report Share Posted January 28, 2014 Same as lukey said i did mine last weekend and jus undone the back one a jacked engine up just enough to clear Link to post Share on other sites
Recommended Posts