isobarboy 25 Posted March 13, 2014 Report Share Posted March 13, 2014 Sorry if been up. Before but I couldn't find any info. I had maf sensor with the 3mm wide plastic strips running on where the sensor is. That's broke. So brought a new maf. This one's with the 2 wires. Question is;1. Will if physically fit into the same spot? 2. Will it work the same? Kind regards all. Link to post Share on other sites
Lukey. 381 Posted March 13, 2014 Report Share Posted March 13, 2014 Hot film and hot wire aren't interchangeable Link to post Share on other sites
isobarboy 25 Posted March 13, 2014 Author Report Share Posted March 13, 2014 So the replacement part won't work? Link to post Share on other sites
Lukey. 381 Posted March 13, 2014 Report Share Posted March 13, 2014 put the part nos up for them both and ill have a look next time i get on Link to post Share on other sites
Solution isobarboy 25 Posted March 15, 2014 Author Solution Report Share Posted March 15, 2014 Tried it. Works a treat. jamesw6810 1 Link to post Share on other sites
Lukey. 381 Posted March 15, 2014 Report Share Posted March 15, 2014 (edited) Is yours obd1? Edited March 15, 2014 by Lukey. Link to post Share on other sites
isobarboy 25 Posted March 27, 2014 Author Report Share Posted March 27, 2014 You know ive never looked..how do I tell again. Link to post Share on other sites
Lukey. 381 Posted March 27, 2014 Report Share Posted March 27, 2014 There's a guide on here somewhere Link to post Share on other sites
Recommended Posts