nolongervr6 4 Posted March 31, 2014 Report Share Posted March 31, 2014 My engine has been sat in pieces for a few years, i'm looking to get it back together to getting the car back on the road again. But i'm not sure how to remove the surface rust from the cams (inbetween the loboes) without damaging them. Has any one any guide/advise on putting a VR6 engine back together? Link to post Share on other sites
Big J 283 Posted March 31, 2014 Report Share Posted March 31, 2014 Hand held wire brush, a tin of elbow grease and plenty of fresh oil. By the time you've finished you'll have learnt a valuable lesson. VR6Pete and michael5556 2 Link to post Share on other sites
Recommended Posts