JayzVr 106 Posted August 9, 2015 Report Share Posted August 9, 2015 Bought this engine mount off a member on here was going to go about fitting it today but my mate said its not the front subframe mount can anyone tell me which one it is? Link to post Share on other sites
Russvrt 85 Posted August 9, 2015 Report Share Posted August 9, 2015 Looks like front to me ,big red but replaces the waffled rubber insert other bit goes under the mount ?I think,I'm doing the same to mine but using hockey pucks stacked up instead. Link to post Share on other sites
JayzVr 106 Posted August 9, 2015 Author Report Share Posted August 9, 2015 Looks like front to me ,big red but replaces the waffled rubber insert other bit goes under the mount ?I think,I'm doing the same to mine but using hockey pucks stacked up instead.I'm not sure mate the red mount looks a lot bigger than the one that's fitted?I looked at the other two mounts and they look nothing like it, only way to find out is take the old one out I guess Link to post Share on other sites
c00k 435 Posted August 12, 2015 Report Share Posted August 12, 2015 (edited) Looks like front mount to me. Looks like you have it upside down in photo. Smaller part siting under crossmember. Larger part on top of crossmember.. Bolt goes through top, and screws in to metal bar inside. Should be direct replacement. Both other mounts (gearbox and rear engine mount), have mounting and bolt holes on the side aswell as the top. As they sit inside cups, and bolt from the side, not underneath. Usally both of these mounts are one piece ready to fit. So no side mounts, plus it's in two sections, defiantly front mount. Edited August 12, 2015 by c00k Link to post Share on other sites
Recommended Posts