trackman 0 Posted June 26, 2005 Report Share Posted June 26, 2005 Finally got round to getting my engine back in with it's shiny new Schrick Manifold. Come to connect up the vacuum hoses and the wiring today, only to stumble on the wiring.Is there anyone that's fitted one that can tell me where to connect the wiring up to?Also where have people fitted their control boxes. I'm guessing it needs to go inside the cabin, but which route through the bulkhead?Cheers,Rich Link to post Share on other sites
VR6Pete 1,455 Posted June 26, 2005 Report Share Posted June 26, 2005 I fitted my control box, vacuum tank and solonoid under my slant pannel....Wiring on the otherhand:http://www.vr6oc.com/installation-vr6.pdfPete Link to post Share on other sites
trackman 0 Posted June 26, 2005 Author Report Share Posted June 26, 2005 Pete.What/where's the slant panel?On the wiring front, I've got the instructions as per the link already. It's the 'blue cable to rev-counter input signal' bit I'm struggling with. I've had a look in the Bentley manual wiring diagrams, but it's not clear (to me!) which wire is the input signal.Cheers,Rich Link to post Share on other sites
VR6Pete 1,455 Posted June 26, 2005 Report Share Posted June 26, 2005 Where your wiper motor/ECU is located.... I you look through the "Schrick group buy" thread you will probably find out the info you nee. Link to post Share on other sites
Eat this 2 Posted June 26, 2005 Report Share Posted June 26, 2005 I THINK its pin 22 or 23 its greeen and black iirc Link to post Share on other sites
trackman 0 Posted June 26, 2005 Author Report Share Posted June 26, 2005 Cheers guys. I'll take a look at that group buy thread. Link to post Share on other sites
Recommended Posts