jasonoldy69 1 Posted August 15, 2017 Report Share Posted August 15, 2017 I've been troubleshooting the cooling and found this - see photo This is the 3-pin plug for the rad temp sender (2 stage), and it looks knackered. How would you go about replacing this? Link to post Share on other sites
Philly-R6 28 Posted August 16, 2017 Report Share Posted August 16, 2017 (edited) The housing looks dirty, more than anything else. If you are up for it, you could try removing the wiring terminals, cleaning everything and re-insert them. If the terminals are corroded (going green) clean them with those abrasive pads - or even sand paper... I use a tool by Laser which fits most of the terminals on the Corrado/Golf3: http://www.lasertools.co.uk/product/3932/ Just take a few photos before you start, so the terminals go back where they came from. Edited August 16, 2017 by Philly-R6 updated url for abrasive pads Link to post Share on other sites
Recommended Posts