Timothy_Ellis 23 Posted September 12, 2017 Report Share Posted September 12, 2017 When I did my swap the line wasn’t disconnected long, so this wasn’t an issue. Now that I’ve got it back together after doing my chains, I can’t seem to get the air out of the slave cylinder. Any tips? Link to post Share on other sites
mattvr6 133 Posted September 15, 2017 Report Share Posted September 15, 2017 Pressure bleed it Link to post Share on other sites
Timothy_Ellis 23 Posted September 15, 2017 Author Report Share Posted September 15, 2017 As in pressure at the bleeder valve? Sorry I’m new to this style of slave. I have a new CNC bleeder block from ecs almost here so I’m holding off til it gets here. Link to post Share on other sites
mattvr6 133 Posted September 15, 2017 Report Share Posted September 15, 2017 Pressurise where ur brake fluid is then bleed if from there Link to post Share on other sites
Username3001 0 Posted October 9, 2017 Report Share Posted October 9, 2017 I found that my Stanley hammer was just the right length to cram in between the pedal and lower dash to keep the down.Worked great. Link to post Share on other sites
Recommended Posts