DommyVR6 0 Posted February 12, 2006 Report Share Posted February 12, 2006 anyone got a quick guide or tips for fitting an rear near side axle stub axle stub. im still trying to figure out why my vr has been pulling to the left so much now it looks asthough the stub alxe might be bent as the wheel is sitting funny (tillted in at the top more than the off side rear and wearing the tyre uneve, funny that youd of thought they would of noticed when they checked full camber and allignmemnt 4 months ago. would this cause it to pull to the left. Link to post Share on other sites
BigSi 0 Posted February 18, 2006 Report Share Posted February 18, 2006 Sounds like the camber is out to me. Are you sure the garage definitely checked the Camber? When I got mine done I was suprised how many garages didn't seem to understand what I wanted doing when I asked for Camber alignment!!! Lots of places will just do the tracking.It will pull all over the place is the camber is out, espcially if its not even on both side of the car.Also when I when I got my Camber set the guy said tyres can have an effect on the pull. I swaped back to front and the pulling went away! Link to post Share on other sites
DommyVR6 0 Posted February 18, 2006 Author Report Share Posted February 18, 2006 the camber was adjusted on the front but you cant do the rears you can only check them and they didnt mention they were out of line or anything. my mate who knows golfs insideout is now gunna fit my stub axle anyhow he reckons it is bent he said they are quite comon as they have heavy load bearing on a small diameter shaft. Link to post Share on other sites
Recommended Posts