Jump to content

Recommended Posts

I asked Vince @ Stealth the same question and his advice was to use the 2 prong type plugs (as used in early OBD1 engines) and replace them every 10k miles

These plugs are approx £3 each so you end up saving a little compared to if you use the platinum type plugs (approx £10 each) which last for 3 yr's or so

Link to post
Share on other sites

ive been using BOSCH F6DTC, they were recomended especially if u r using a charger cos they do not break down under immense heat. I have used them on my vr before intalling the charger. They worked fine, they are three prong though. as for platinum I have not heard good things as they tend to last only 10k miles, so no point purchasing. the denso plugs are supposed to be amazing, and are used by many americans. Dont think they last long at all though

Link to post
Share on other sites

I tried some NGK iridiums and didn't notice any difference in the way the engine ran, but they would last longer than standard ones. Which is no bad thing if you've got a Schrick manifold.

I would tend to go along with what Vince says to be honest.

Kev

Link to post
Share on other sites
×
×
  • Create New...