6potmkII 0 Posted April 11, 2006 Report Share Posted April 11, 2006 hey guyshad a prob with transponder and ecu codes, but had vagcom to it, deleted the codes and reprogrammed it all, and still the same prob!still comes up with the error "ecu immob blocking" (something along those lines) even after its been programmed! any ideas? could it be F'd ecu or transponder box?what i dont understand is, it was all working fine in the donor car.any help much appreciated Link to post Share on other sites
vr200 0 Posted April 11, 2006 Report Share Posted April 11, 2006 maybe the ecu m8, my m8 had the same prob, put the engine ect.. in and the earth points in the loom were dirty so it fried the ecu, just kept turnin over but not fireing Link to post Share on other sites
6potmkII 0 Posted April 11, 2006 Author Report Share Posted April 11, 2006 what year was his vr6? what did he do about the transponder and key?so it fired up but kept cutting out, same timing each time yeh? Link to post Share on other sites
vr200 0 Posted April 11, 2006 Report Share Posted April 11, 2006 no it didnt fire at all m8,he bought a brand new ecu for £600 Link to post Share on other sites
6potmkII 0 Posted April 11, 2006 Author Report Share Posted April 11, 2006 so how did he match his transponder and key to it? Link to post Share on other sites
vr200 0 Posted April 12, 2006 Report Share Posted April 12, 2006 they did it when he bought the new ecu m8, he sent them the old one to go with it! Link to post Share on other sites
Recommended Posts