vr6g 0 Posted April 27, 2006 Report Share Posted April 27, 2006 Hi guys Was wondering does anyone know the profile height on a standard vr6 cam? E.g from the bottom of the base circle to the top of the lift. Many Thanks Gareth Link to post Share on other sites
vr6g 0 Posted April 27, 2006 Author Report Share Posted April 27, 2006 BUMP ^^^^^ Link to post Share on other sites
matth76 1 Posted April 27, 2006 Report Share Posted April 27, 2006 230 something degrees...I think. Sure someone on here will give an exact figure. Not sure on profile height though. I just had 268 Eurospec cams fitted. Boy have they made an improvement. Eurospecs are the same as Shrick cams but slightly cheaper. Not huge boost in power but pulls noticably harder throughout the rev range. Going to get a rr session and possible remap in a month's time. Are you considering new cams? Link to post Share on other sites
vr6g 0 Posted April 27, 2006 Author Report Share Posted April 27, 2006 yeah i am, a friend has a set of vr6 "fast road cams" in his garage out of a vr he used to own. They where only in for a few hundred miles before the inevitable.... SMASH! lol. just wanna make sure they are so i don't waste my time! it isn't exactly a job you do in 5 mins, lol Link to post Share on other sites
matth76 1 Posted April 27, 2006 Report Share Posted April 27, 2006 You will need to check the fuelling is ok after adding the cams and there isnt any pinking... a remap normally sorts this. Link to post Share on other sites
vr6g 0 Posted April 27, 2006 Author Report Share Posted April 27, 2006 oh i know she'll be going for a full remap and rolling road set up! :-) Link to post Share on other sites
vr6g 0 Posted April 29, 2006 Author Report Share Posted April 29, 2006 bump!!! Link to post Share on other sites
Eat this 2 Posted April 30, 2006 Report Share Posted April 30, 2006 yeah i am' date=' a friend has a set of vr6 "fast road cams" in his garage out of a vr he used to own. They where only in for a few hundred miles before the inevitable.... SMASH! lol. just wanna make sure they are so i don't waste my time! it isn't exactly a job you do in 5 mins, lol[/quote']i hope youv got the tappets that were runin with the cams failing that buy a new set its a badidead to use new cams ib ikd followers the bed in together Link to post Share on other sites
Recommended Posts