Jump to content

Leaderboard

  1. al_mooring

    al_mooring

    Members


    • Points

      2

    • Content Count

      115


  2. c00k

    c00k

    Members


    • Points

      2

    • Content Count

      559


  3. Bealieboy

    Bealieboy

    Members


    • Points

      1

    • Content Count

      2,397


  4. D11PS

    D11PS

    Members


    • Points

      1

    • Content Count

      296


Popular Content

Showing content with the highest reputation on 06/11/2014 in all areas

  1. Got one side in primer now moving along to the fire wall and other side. Here are a few pictures of the progress Also bought some drop in 8:1 wossner pistons and genuine rod bearings
    2 points
  2. Some of the leather inside of the car was starting to look abit warn, So im going to re-dye it. I prep the leather before dyeing . Giving it a very good clean, using a leather deep cleaner to open up the pours of the leather. then using leather prep, which is just acetone. to remove the leather finish. not the colour just the finish. Finally alcohol cleaner which is isopropanol or IPA. I realised this after buying the kit haha As I use both these chemicals in work to clean stuff, and I know the smell a mile off. Then spray the leather using leather dye a mini compressor and a spray gun on
    1 point
  3. Few more little tweaks to the engine bay. Bought some red conduit to cover the wire at the back of the chassis leg. Not a huge fan of the coloured stuff, but bought some thinking I will give it ago... if I don't like it I can take it off in a matter of minutes. advert stated colour coded cable ties who the fuck does there colour matching haha. I didn't end up using cable ties anyway. Used only a small amount from what I bought, only covered the wires that sat over the red paint in this small area. I didn't like the red not matching, so I colour coded the conduit so it was a perfect match
    1 point
  4. I wouldn't mind knowing the same. I would of thought the copper grease would get caked in shit off the roads Sent from my SM-G900F using Tapatalk
    1 point
  5. Vince12v

    Rear axel bush swap!

    I think my bushes are shagged so I think I'll notice any difference from what I got!
    1 point
  6. Bealieboy

    1997 VW Golf VR6 mk3

    Sounds good bennyk. We'll have to look into that, perhaps try the one where you rolled before and tag the VXROC onto our session this time! Would be good to see the difference our latest mods make. I reckon my hella quads will give me another 5hp possibly 6 if I take your pukka headlight mask Ben. Sent from my iPhone using Tapatalk
    1 point
  7. D11PS

    Rear axel bush swap!

    It made it a tighter and firmer ride.. People have said it made the ride too harsh but I suppose it depends on the setup you have. I noticed the difference straight away and I liked it. It's down to each individual.. Sent from my iPhone using Tapatalk
    1 point
  8. Safe to say that one is toast!
    1 point
  9. bennyk

    1997 VW Golf VR6 mk3

    Maybe I'll have my charger on by then! More chance of that than me winding my coilovers up bealieboy! Lol! We'll have to go to a different rolling road! Sent from my iPhone using Tapatalk
    1 point
  10. i struggled to find one for my head when i was rebuilding mine. good luck with the build fella
    1 point
×
×
  • Create New...