Leaderboard

Well after my chat with vince yesterday, these arrived today Should work well with this I have been sitting on a while Now this is a stage 2 supercharger set up, to replace the current stage 1 setup the car is running. Should see the car push out over 285bhp once all fitted :-) Lots more bits to arrive in the next few days. I am also sitting on quite a few parts I have been collecting for the last few months

Federal 595rsr

Well I'll throw mine on

I'm no expert, but I think the oil is a red herring here. I can't see how that would periodically affect your idle. It's most likely some sort of sensor-related issue in my opinion. Idle control valve, MAF etc...

Fancy retrims done right are good, this was botched from the outset, edges not fitted right, trim bits not put in the right places, then lots of bits held on with double sided sticky tape hiding bits that simply didn't fit. My fault partly as lots of the problems were there when I purchased the car, but either I couldn't see them (hidden), I didn't notice in the 30 min look round the car or at the time I thought they weren't too bad..... Just when you start adding them up, there are a lot of issues. The stage 1 charger set up, I think is a z engineering set up

1) VR6Pete 2) Cabbs 3) mikewoot Club Chairman

Cumvag photo shoot by Koosh! Many thanks dude!!!!!

hi, I'm Michael.I'm not a lurker but hello to all those who have confessed. And supercharger and shrick! get a build thread up man!

its getting a bit bonkers right enough. Need to get a catch up soon mate