Jump to content

pontygtimk2

Members
 View Profile  See their activity

  • Content Count

    11

  • Joined

  • Last visited

 Content Type 

Everything posted by pontygtimk2

  1. pontygtimk2

    mk4 shifter

    pontygtimk2 posted a topic in The MK2

    I read before if you use the mk4 cable change you have to use the mk4 gearbox tower that the cables attaches to, does anyone who also use this know why and if you must regards mike
  2. pontygtimk2
    its just the feed thanks
  3. pontygtimk2
    this is really a genral question aboout the pressure that the pipe has to deal with, the pipe on my mk2 vr conversion is too short and i am finding it hard to source pas pipe what other types of pipe can i use that can hold the pressure i mean does it hold more pressure than say fuel pipe as i could use that other wise, regards.
  4. pontygtimk2
    I have mk4 rears on my mk2 and mk1 so i would have thought so, is your servo and m/c up to the job?
  5. pontygtimk2
    there was a lot of discussion about this cable on mk2vr6 and some of the guys found that the 1.3 was a pain to fit correctly , i used a 1.1 bacle from an 084 gearbox which even has the correct end for the "fork" side the only issue is i cant remember if it wsa a mk1 ot mk2 but i have the part number will dig it out tomorrow.
  6. pontygtimk2
    its because in the mk3 it is attacted to part of the body or part of the car that you dont use in the mk2 if i remember correcly, just knock up a bracket or something
  7. pontygtimk2
    fix the one of have as the "new" engine you put in could end up the same way in a bit
  8. pontygtimk2

    MK2 VR6

    pontygtimk2 replied to mashed's topic in The MK2

    Are ypu using ABS as the cables that are free maybe from the ABS on the mk3 also check your relays are good espically the 109 other than that your ecu could be bad
  9. pontygtimk2
    My father has always sworn by the toyos but lucky hes has the money to replace them as often as they wear which is pretty quick
×
×
  • Create New...