BrickTop

Ah OK, any idea which wires or pins from the ECU? I can just buzz them back as long as I know which pins they are or wires. Still just a bit at a loss lol :| boos

Coolio! Still not sure where those lambda wires go though in the loom! Anyone know that little nugget?

anyone? I will send you beers and dirty women!!!

I had a similar problem with my 20v and it turned out the lambda was shot. It was overfueling like a bugger and would cut out when I came to stop but when you got past low revs it ran ok. Same with off acc. and it would stutter and chuck out huge black smoke. Not sure if it's the same on the VR but thought it was worth chucking in my 2p!

Hey guys, new here but told that this is the place for all wonder and wisdom when it comes to VR's so alas, I am here to try and soak some of that wisdom up and finally try and get this bloody thing going and out my garage! Basically I dropped a 2.9 lump in to my 1.8 mk3 and I'm using the loom from a 2.8 VR all was going pretty well, I just have a couple of wiring questions and sensor questions really. Firstly, there is a 2nd knock sensor (I think that's what it is?) around the back of the engine on the block, which is secured in that bracket that sits on the rear drivers side engine mount,