joeboy

You can get the black carbon fibre wrap form eBay, a sharp knife e.g scalpel, craft knife. A heat gun or a hair dryer will work. And to clean the pieces I use white spirit or methylated spirit with industrial blue paper towels. If u get stuck there's lots of videos on YouTube to help you out.

I agree it is easy with a bit of patience and some heat.

It would be £40. The only way I would be able to do it was if u sent the parts to me because its a bit of a trek to south Wales and i only do this as as side job. I would send them bk for free.

The centre dash do mean the same as in the picture of my VR just around the heater controls.

Well I haven't been doin it long, it start from a fiver which would be the the the door handles the door handle surrounds and around air vents. And about £30 for a centre dash like in the picture of the 206.

I've been recently indulging in some carbon fibre wrapping. I started off doing some on my own car, then a few mates said it looks good and they would like some down too and it's gone on from there. Have a look at my Facebook page and tell me what u think. Facebook/tidywraps

Cheers lads got one order off the bay.

Mornin peeps, yesterday I noticed a rattling sound comin from the engine, then when havin a look in the engine bay I noticed wat I think is a pulley , it has abelt going round it, the pulley has abit of play in it, I have a vid on YouTube it's only about 14 seconds long , please could I have some help on what to do asap as this is my every day car and will be lost with out it. Oh and it's a 95 mk3 golf vr6.

Egg

Cheers mate I left it running for a little bit longer, and it kicked in after a while.

Hi peeps, just changed two hoses on the oil cooler which have split, had it runnin for about ten minutes the temp hit it's norm of 90, now the fan usually kicks in when it just goes over the 90 mark, now I suspect that this is probally why the hoses split, but can some 1 shed some light on why the fan isn't kicking in. Thanks Joe

Vegas

Pizza

That's mental.